This is a DMX signal terminator for DMX Decoder / Drivers that use an XLR3 type connection for DMX Signal to LED Lights. This terminator will allow you to terminate the DMX signal in the last DMX driver of your system. For use with DMX systems using more than two XLR3 DMX drivers.
PX24501 RGB LED DMX Driver XLR3 & RJ45, 12-24VDC 5A/CH
SKU: LC-OL-DMX-PX01View Product Page This DMX512 driver allows for LED lights to be controlled via a DMX controller by accepting both DC supply voltage and your DMX controller signal and distributing it to attached LED lights. This driver accepts XLR-3 type connections or RJ45 connections for the DMX signal input and output and has a screw-down terminal block for DC input power and 4-wire common anode output to your LED lights. This driver is able to accept 6-24VDC at 5A per channel (three channels total). You can set the starting address of the DMX driver via DIP switches located on the back of the unit. Please note that each DMX driver requires 3 addresses in the DMX universe being used. One cat5 Ethernet cable included with each driver for daisy chaining multiple drivers. LED light test mode available with DMX driver. Systems with more than two DMX drivers being used require an XLR3 or RJ45 DMX terminator cable on the last DMX driver in the series.
DMX Driver RGB LED, 24VDC 2A/CH
SKU: LC-OL-DMX-D24View Product Page A small sized DMX Driver which allows you to connect your RGB LED Lights, LED Lighting, LED Ribbon strips or RGB LED Modules to a DMX-512 Lighting controller. Then by the use of PWM and DMX, you can change the color and dimming of your RGB LED lights. See more
For 24VDC systems only. 2A per channel with a maximum power of 144W at 24VDC. For use with 4 pin, 3 loop, common anode style RGB LED and LED Lighting. All wires are bare and need to be connected using a connector or wire nuts. NOTE: To change the DMX address of these modules you need to have us set the address for each module you buy (specify addresses when ordering) or you can purchase the DMX Editor Controller, which enables you to change the addresses, of these modules, as often as you like. Each DMX Driver uses 3 DMX addresses. Hide