This Product Has been Discontinued
This product has been discontinued or is no longer available from the manufacturer, we apologize for any inconvenience. Please browse our similar replacement products found below.
PX24500 RGB LED DMX Driver, 12-24VDC 5A/CH
SKU: LC-OL-DMX-PX View Product Page
The most popular DMX Driver style PX24500, which allows you to connect your RGB LED Lights, LED Lighting, LED Ribbon strips or RGB LED Modules to DMX512 or DMX1990 Lighting controllers. Then by using PWM & DMX, you can change the color and dimming of your RGB LED lights. For 12 to 24VDC systems only. Includes one 6' Cat5 cable with RJ45 jack connectors. 5A per channel with a maximum power of 180W / 12VDC or 360W / 24VDC. For use with 4 pin, 3 loop, common anode style RGB LED and LED Lighting. Can be connected to DMX512 signal using RJ45 connectors and Cat5 cables. Unit has DIP switches on the side to manually change the DMX address of each driver. Each PX24500 Driver uses 3 DMX addresses. RGB LEDs and power supply are connected using screw down style connectors. RoHs, CE approved.
PX24501 RGB LED DMX Driver XLR3 & RJ45, 12-24VDC 5A/CH
SKU: LC-OL-DMX-PX01 View Product Page
This DMX512 driver allows for LED lights to be controlled via a DMX controller by accepting both DC supply voltage and your DMX controller signal and distributing it to attached LED lights. This driver accepts XLR-3 type connections or RJ45 connections for the DMX signal input and output and has a screw-down terminal block for DC input power and 4-wire common anode output to your LED lights. This driver is able to accept 6-24VDC at 5A per channel (three channels total). You can set the starting address of the DMX driver via DIP switches located on the back of the unit. Please note that each DMX driver requires 3 addresses in the DMX universe being used. One cat5 Ethernet cable included with each driver for daisy chaining multiple drivers. LED light test mode available with DMX driver. Systems with more than two DMX drivers being used require an XLR3 or RJ45 DMX terminator cable on the last DMX driver in the series.
12 Channel LED DMX Decoder, 5-24VDC 5A/CH
SKU: LC-LT-DMX-12CH View Product Page
This DMX decoder allows for 60 Amps of LED lights to be controlled via a DMX control signal over 12 channels. With two DC power inputs, one for channels 1-6 and the other for 7-12, this decoder can control 6 channels of LED lights of similar or variating voltage inputs. DMX connections are made using either XLR-3 type connections or RJ45 ethernet connections for the DMX signal input and output. There are a total of four, 3 channel, common anode outputs with screw-down terminal blocks for easy connection and control. This decoder is able to accept 5-24VDC at 5A per channel (twelve channels total) for max load of 300W/5V, 720W/12V, or 1440W/24V. You can set the starting address of the DMX decoder via DIP switches located on the back of the unit. Please note that each DMX decoder requires 12 addresses in the DMX universe being used. A built in LED light test mode is available with this DMX decoder, CE, RoHS approved. A 5-24VDC low voltage driver is required to power this unit and must be suffice to power the load of the light output. Systems with more than two DMX decoders being used require an XLR3 or RJ45 DMX terminator on the last DMX decoder in the series.