Plastic End Caps for PDS4 Aluminum Extrusion

SKU: EX-KL1-CAP-1     View Product Page
We have a small selection of colored plastic end caps for our .5" deep PDS4 square shaped LED Aluminum Extrusions to give your light profile a clean and finished look. Available in white, black, or silver plastic, this cap will fit both the clear and frosted diffuser styles. The faux metal silver finish does not allow for light transmittance while the plain plastic cap does show light through the plastic This product is sold individually and in single units in order to pair with holed end caps if needed. With proper sealing techniques of your PDS4 extrusions with HS outdoor covers these caps can achieve an IP67 water-resistant rating and can be used in outdoor environments.

Plastic End Cap with Post for PDS4 .5" Square Extrusion

SKU: EX-KL1-CAP-1P     View Product Page
This product is a plastic end cap for our .5" deep square shaped LED Aluminum Extrusions with a built in electrical conducting pole in order to create custom lamps and hanging fixtures with a clean and finished look. Simply solder your positive connection to one end and your negative connection to the other. This cap will fit both the clear and frosted diffuser styles. This product is sold individually and in single units in order to pair with other end caps if needed. With proper sealing techniques of your PDS4 extrusions with HS outdoor covers these caps can achieve an IP67 water-resistant rating and can be used in outdoor environments.

(2) Extrusion Mounting Clips for Most KL1 Profiles

SKU: EX-KL1-CLIP-2     View Product Page
A set of 2 clips for mounting a variety of our KL1 type LED Aluminum Channels with 0.44" mounting base. Works with a number of our aluminum channels for mounting to any drillable surface. Comes with 2 clips for a secure mounting solution that is simple to install. See a list of compatible extrusions that can be used with these mounting clips below. A minimum of two clips per 1M channel are recommended for a secure installation.