This product is an Aluminum Extrusion for your LED Strip Lights available in 1M lengths that is made especially to create a 45° beam angle from a 90° surface. With its slim design this product makes for a great housing and also a great heat sink for your custom LED project. If you are looking for a finished look for your LED Strip Lights this is definitely the product for you. Perfect for under cabinet, under stairs, closets, exhibits, furniture, work stations, or any project needing a 45° housing for your LED Strip Lights. This product does not fully diffuse your LED Lights, individual lights can still be seen through the frosted cover. Note: LED Strip Light Quick Connectors are too wide to be used with this product. Product is non water-resistant and not meant to be exposed to outdoor elements. This product is available in 2M lengths, please call 775-636-6060 to order.
|Dimensions||39.37"L x 0.75"W x 0.75"H|
(2) Extrusion Mounting Clip for 45 ALU Triangle Profile
SKU: EX-KL1-CLIP-1-2 View Product Page
A set of 2 clips for mounting our triangular extrusions. Works with triangular extrusions with no wings only. Comes with 2 clips for a secure mounting solution with no drilling or adhesive.
Plastic End Cap for 45 ALU .5" Triangle Extrusion
SKU: EX-KL1-CAP-5 View Product Page
This product is a plastic end cap for our .5" deep triangular shaped LED Aluminum Extrusions to give your extrusion a clean and finished look. This cap will fit both the clear and frosted diffuser styles. This product is sold individually and in single units in order to pair with holed end caps if needed. With proper sealing technique and use of an HS outdoor cover these caps can achieve an IP67 water-resistant rating and can be used in outdoor environments.
Plastic End Cap with Hole for 45 ALU .5" Triangle Extrusion
SKU: EX-KL1-CAP-5H View Product Page
This product is a plastic end cap for our .5" deep triangular shaped LED Aluminum Extrusions to give your extrusion a clean and finished look while allowing wires to pass through the end cap. This cap will fit both the clear and frosted diffuser styles. This product is sold individually and in single units in order to pair with closed end caps if needed. This product is non water-resistant and not meant to be exposed to outdoor elements.
3M VHB Mounting Tape, 10mm x 10ft
SKU: LA-SC-MT-10-10 View Product Page
This is a double sided 3M VHB 5952 Mounting tape for mounting LED Products such as aluminum extrusions, power supplies, controllers, Strip Lights, Modules or any other product that requires an adhesive to mount. Each roll contains 10ft of 10mm wide VHB tape. Product will not stick to Silicon. Do not use to mount any item that weighs more than 5lbs. Note: This is a permanent product and may cause damage if removed.