1 Meter Aluminum Extrusion with Wings and Clear Diffuser- .5" Deep

Plastic End Cap for PDS4-K .5" Square / Wings Extrusion

SKU: EX-KL1-CAP-3     View Product Page
Our black and white plastic end caps for our .5" deep PDS4-K square shaped LED Aluminum Extrusions with wings give your extrusion a clean and finished look. This cap will fit both the clear and frosted diffuser styles. This product is sold individually and in single units in order to pair with holed end caps if needed. With proper sealing techniques of your PDS4-K extrusions using an HS outdoor cover these caps can achieve an IP67 water-resistant rating and can be used in outdoor environments.

Plastic End Cap with Hole for PDS4-K .5" Square / Wings Extrusion

SKU: EX-KL1-CAP-3H     View Product Page
This product is a plastic end cap for our .5" deep square shaped LED Aluminum Extrusions with wings to give your extrusion a clean and finished look while allowing wires to pass through the end cap. This cap will fit both the clear and frosted diffuser styles. This product is sold individually and in single units in order to pair with closed end caps if needed. This product is non water-resistant and not meant to be exposed to outdoor elements.

(2) Extrusion Mounting Clips for Most KL1 Profiles

SKU: EX-KL1-CLIP-2     View Product Page
A set of 2 clips for mounting a variety of our KL1 type LED Aluminum Channels with 0.44" mounting base. Works with a number of our aluminum channels for mounting to any drillable surface. Comes with 2 clips for a secure mounting solution that is simple to install. See a list of compatible extrusions that can be used with these mounting clips below. A minimum of two clips per 1M channel are recommended for a secure installation.