SKU: LC-OL-1RGBA
This Product Has been Discontinued
This product has been discontinued or is no longer available from the manufacturer, we apologize for any inconvenience. Please browse our similar replacement products found below.
RGB LED Signal Amplifier / Repeater, 12-24VDC 5A/CH
SKU: LC-EU-2RGBA View Product Page
A RGB LED Signal Amplifier / Repeater that can be used to add more RGB LED modules, RGB LED Ribbon or RGB LED Lights to your existing RGB LED controller and will allow the additional lights to perform the same color changes as the RGB lights that are connected to the main controller. By adding this RGB Amplifier and another power supply you can add more RGB Lighting to your existing RGB lights. For use with Constant Voltage power, 12-24VDC systems only. 5A per channel with a maximum power of 180W at 12VDC and 360W at 24VDC, through this amplifier. For use with 4 pin, 3 loop, common anode style RGB Lighting. The power supply and RGB signal wires are connected by screw down type wire connections.
RGB LED Signal Amplifier / Repeater, 5-24VDC 8A/CH
SKU: LC-LT-1RGBA View Product Page
This signal amplifier is capable of extending your 5-24VDC RGB control signal an impressive 8 amps x 3 channels. Capable of larger loads than our other signal amplifiers this amplifier can extend your control signal 288W at 12VDC or 576W at 24VDC. 3 Channel RGB signal amplifiers can be used to add more RGB LED modules, RGB LED strip lights or any 5-24VDC constant voltage RGB LED Lights to your existing RGB LED controller, allowing for unison color changing from your RGB LED controller. You can also use this amplifier with a single color PWM dimmer to extend your dimming to 3 outputs of 96W at 12VDC or 3 outputs of 192W at 24VDC. For use with PWM dimmable 5-24VDC Constant Voltage power systems only. For use with 4 pin, 3 loop, common anode style RGB Lighting. The input power and RGB signal wires are connected by screw down type wire connections.
Waterproof Mini RGB LED Signal Amplifier, 5-24VDC 4A/CH
SKU: LC-LF-8AMP View Product Page
This Mini Waterproof RGB LED Signal Amplifier is IP68 rated and can be used to extend the control signal on any outdoor or indoor LED lighting project using 5-24VDC constant voltage RGB LEDs. When you have exceeded the maximum load of your RGB LED controller use this signal amplifier to provide the same control signal to another 12A (4A x 3CH) of RGB LED strip lights, modules, or fixtures. By adding this RGB Amplifier and another power supply you can add up to 144W of RGB Lighting at 12VDC or 288W at 24VDC to your existing RGB lights. For use with 4 pin, 3 loop, common anode style RGB Lighting. Simple bare wire connections make installation a breeze on any new or existing project. The waterproof rating is not designed to be submersed, or meant to be exposed directly to outdoor elements.