(5) WP Ribbon to Wire Connector Kits for DX 50/50 10mm RGB LED Strips IP67

Description

This waterproof RGB strip light connector kit includes 5 connectors, 5 wire leads, 1 tube of silicone adhesive with cone tip applicator and 5 plastic glue hole plugs. Simply place the wires and strip light into the connector and snap into place. Then apply the silicone adhesive into the connector to seal contacts and create an IP67 waterproof connection. This waterproof connector can only be used with our waterproof RGB Lux 10mm LED Strip Lights (RL-DX-RLX-RGB-T-10). The strip light will hold tighter if you leave the silicone housing on the bottom side of the strip with VHB tape removed. Copper pads of strip must go under conductive tabs of connector to function properly. See the installation guide below.