This is a 3 foot long DMX signal Cable for any DMX application requiring XLR3 DMX output to an RJ45 DMX input. This cable will allow you to connect to a DMX controller, that has XLR3 output plugs, and any DMX Driver or controller with RJ45 connector. 36" cable included, XLR3 Male, plug on one end and RJ45 jack on the other end.
SKU: LC-NL-DMX-U9View Product Page
This Nicolaudie SLESA-U9 is a 256 Channel DMX Control system with included PC Software to create fully customizable LED lighting scenes. Use with our 3 channel DMX decoders to control up to 85 RGB LED Fixtures or 256 Single Color LED fixtures using our single channel DMX decoders. Save up to 20 different lighting scenes and play them using the shuffle buttons on the controller or use any of the eight external ports for relay triggering of a scene. This DMX control system can also control any DMX Lighting systems, Lasers, Scanning heads, fog machines and other stage lighting applications. This system can be run live via the included software and a USB connection or you can download scenes to it allowing this DMX controller to run as a stand alone unit. This controller has 8 port connections to change scenes by simple dry switches. 5k memory allows for 439 steps using 60 channels, and 1184 steps using 20 channels. If you are looking for a powerful and affordable DMX controller or you are just starting out learning about DMX control, this is the one for you. Software Disk, Manual and USB Cable included.
PX24501 RGB LED DMX Driver XLR3 & RJ45, 12-24VDC 5A/CH
SKU: LC-OL-DMX-PX01View Product Page
This DMX512 driver allows for LED lights to be controlled via a DMX controller by accepting both DC supply voltage and your DMX controller signal and distributing it to attached LED lights. This driver accepts XLR-3 type connections or RJ45 connections for the DMX signal input and output and has a screw-down terminal block for DC input power and 4-wire common anode output to your LED lights. This driver is able to accept 6-24VDC at 5A per channel (three channels total). You can set the starting address of the DMX driver via DIP switches located on the back of the unit. Please note that each DMX driver requires 3 addresses in the DMX universe being used. One cat5 Ethernet cable included with each driver for daisy chaining multiple drivers. LED light test mode available with DMX driver. Systems with more than two DMX drivers being used require an XLR3 or RJ45 DMX terminator cable on the last DMX driver in the series.