PX24501 RGB LED DMX Driver XLR3 & RJ45, 12-24VDC 5A/CH
Product Description Close Description
This DMX512 driver allows for LED lights to be controlled via a DMX controller by accepting both DC supply voltage and your DMX controller signal and distributing it to attached LED lights. This driver accepts XLR-3 type connections or RJ45 connections for the DMX signal input and output and has a screw-down terminal block for DC input power and 4-wire common anode output to your LED lights. This driver is able to accept 6-24VDC at 5A per channel (three channels total). You can set the starting address of the DMX driver via DIP switches located on the back of the unit. Please note that each DMX driver requires 3 addresses in the DMX universe being used. One cat5 Ethernet cable included with each driver for daisy chaining multiple drivers. LED light test mode available with DMX driver. Systems with more than two DMX drivers being used require an XLR3 or RJ45 DMX terminator cable on the last DMX driver in the series.
SKU: LA-EL-DMX-CBL6View Product Page This is a DMX signal Cable with a XLR3 female plug on one end and XLR3 male plug on the other with 36" of lead wire in between. This cable will allow you to connect a DMX controller or device that has XLR3 output plugs to our PX24501 or 24 Channel DMX Drivers, or to daisy chain any other DMX LED Drivers with XLR3 connectors.
DMX Signal Cable, XLR3 Male to RJ45 - 36"
SKU: LA-EL-DMX-CBLView Product Page This is a 3 foot long DMX signal Cable for any DMX application requiring XLR3 DMX output to an RJ45 DMX input. This cable will allow you to connect to a DMX controller, that has XLR3 output plugs, and any DMX Driver or controller with RJ45 connector. 36" cable included, XLR3 Male, plug on one end and RJ45 jack on the other end.
Signal Terminator for DMX Driver XLR3 Type
SKU: LA-EL-DMX-TM2View Product Page This is a DMX signal terminator for DMX Decoder / Drivers that use an XLR3 type connection for DMX Signal to LED Lights. This terminator will allow you to terminate the DMX signal in the last DMX driver of your system. For use with DMX systems using more than two XLR3 DMX drivers.
Signal Terminator for DMX Driver RJ45 Type
SKU: LA-EL-DMX-TMView Product Page This is a DMX signal Terminator for use with LED DMX Drivers that use an RJ45 jack. Use the signal terminator on the DMX output of the last DMX Driver in daisy chain. This terminator is needed if you have more than 3 DMX Drivers in a series of daisy chained drivers.