This water-resistant silicone sleeved digital RGB LED flexible ribbon kit with DMX to digital signal decoder is a one of a kind product! The unique DMX to digital decoder box allows for DMX control of digital RGB LED products; Combining the best aspects of both DMX512 and digital control in one solution! This DMX to digital decoder works by interpreting DMX512 signal and outputting each DMX RGB address to its own 4" section of 3 LEDs on our digital ribbon controlled by an 1803 type IC chip. Each 5m roll of flexible digital RGB LED ribbon has 50 1803 type IC chips allowing for roughly 17 meters of ribbon or 170 IC chips to be controlled by one DMX to digital decoder. Each decoder is sold as a kit including one DMX to digital decoder /driver, one 5m roll of water-resistant silicone sleeved digital RGB LED ribbon, one quick-connect ribbon to bare lead wire connector and one 36W / 12VDC wall plug style constant voltage power supply with one 5.5 x 2.1mm male jack to bare lead wire connector. Additional 5m rolls of ribbon may be purchased separately (additional 36W / 12VDC constant voltage power supply included). This product is perfect for the most demanding of lighting designers; allowing for a single strip of digital ribbon to be performing several different functions across several different sections on the same strip of ribbon simultaneously! Please note that our silicone sleeved digital RGB ribbon is water-resistant only; non-submersible and non-UV proof. Each 5M roll includes 20 silicon mounting clips, two ends caps and two end caps with wire holes. A DMX controller (sold separately) is required to send a DMX signal to the included decoder / driver.
SKU: LA-SC-WJ-12-3View Product Page This male 5.5 X 2.1mm barrel jack connector has 12" - 22AWG lead wire attached. Can be used for many projects to add a power supply connection point or mate with a female 5.5 X 2.1mm female plug connector. Sold in sets of 3. Please note this adapter is only rated for a maximum of 5A.
Signal Terminator for DMX Driver XLR3 Type
SKU: LA-EL-DMX-TM2View Product Page This is a DMX signal terminator for DMX Decoder / Drivers that use an XLR3 type connection for DMX Signal to LED Lights. This terminator will allow you to terminate the DMX signal in the last DMX driver of your system. For use with DMX systems using more than two XLR3 DMX drivers.