1 Meter Aluminum Extrusion with Wings and Clear Diffuser- .5" Deep
Product Description Close Description
This product is an Aluminum Extrusion for your LED Strip Lights available in 1M lengths that is made especially to be routed into wood, drywall, or stone for a flush and professional finish. With its slim design this product makes for a great housing and also a great heat sink for your custom LED project. Perfect for under cabinet, under stairs, closets, exhibits, furniture, work stations, or any project needing a thin profile for housing your LED Strip Lights. If you are looking for a finished look for your LED Strip Lights this is definitely the product for you. This product does not fully diffuse your LED Lights, individual lights can still be seen through the clear cover. Note: LED Strip Light Quick Connectors are too wide to be used with this product. Product is non water-resistant and not meant to be exposed to outdoor elements. This product is available in 2M lengths, please call 775-636-6060 to order.
Plastic End Cap for PDS4-K .5" Square / Wings Extrusion
SKU: EX-KL1-CAP-3View Product Page Our white plastic end caps for our .5" deep PDS4-K square shaped LED Aluminum Extrusions with wings give your extrusion a clean and finished look. This cap will fit both the clear and frosted diffuser styles. This product is sold individually and in single units in order to pair with holed end caps if needed. With proper sealing techniques of your PDS4-K extrusions using an HS outdoor cover these caps can achieve an IP67 water-resistant rating and can be used in outdoor environments.
Plastic End Cap with Hole for PDS4-K .5" Square / Wings Extrusion
SKU: EX-KL1-CAP-3HView Product Page This product is a plastic end cap for our .5" deep square shaped LED Aluminum Extrusions with wings to give your extrusion a clean and finished look while allowing wires to pass through the end cap. This cap will fit both the clear and frosted diffuser styles. This product is sold individually and in single units in order to pair with closed end caps if needed. This product is non water-resistant and not meant to be exposed to outdoor elements.
(2) Extrusion Mounting Clips for Most KL1 Profiles
SKU: EX-KL1-CLIP-2-2View Product Page A set of 2 clips for mounting a variety of our KL1 type LED Aluminum Channels with 0.44" mounting base. Works with a number of our aluminum channels for mounting to any drillable surface. Comes with 2 clips for a secure mounting solution that is simple to install. See a list of compatible extrusions that can be used with these mounting clips below. A minimum of two clips per 1M channel are recommended for a secure installation.
3M VHB Mounting Tape, 10mm x 10ft
SKU: LA-SC-MT-10-10View Product Page This is a double sided 3M VHB 5952 Mounting tape for mounting LED Products such as aluminum extrusions, power supplies, controllers, Strip Lights, Modules or any other product that requires an adhesive to mount. Each roll contains 10ft of 10mm wide VHB tape. Product will not stick to Silicon. Do not use to mount any item that weighs more than 5lbs. Note: This is a permanent product and may cause damage if removed.